                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2320484
Assault on Hoth Miniatures by epengr is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

I have fond memories of playing West End Games' long out of print [Assault on Hoth](https://boardgamegeek.com/boardgame/3548/assault-hoth-empire-strikes-back) on my friends living room floor for hours.  

This project has been in the back of my mind ever since I built my first printer.

The scales are all off, dictated by practicality.  The Troops were printed  with a 0.25mm extruder tip at 0.2 mm layers. Most of the result was printed with a 0.4mm tip at 0.2 - 0.3 mm layers.

The Snowspeeder is [Jabberwock's model](http://www.thingiverse.com/thing:1290458) modified for easy printing without support.

The Shield Generator is [Vincent1212's model](http://www.thingiverse.com/thing:1174989), scaled down and dropped on a base.

All other models were designed from scratch.

Tips always appreciated... 

Enjoy!





# Print Settings

Printer: Prusa Mendel
Rafts: No
Supports: No