                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1807372
Barrow Entrance & Mossy Moorstone by Gh0stC0de is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

  I designed this barrow entrance after those I have seen in western Europe. The entrance is small, suited better for crouching or crawling than upright entry, and it is built into the earth with a simple stone frame. This will serve as an entrance to any subterranean dungeon or grotto. Whether it's a barrow, a hideout, or a desert tomb, all you need to do is change the color scheme to suit your locale.The standing stone is designed as a marker, I will have characters follow these monoliths to the barrow itself. 

# Print Settings

Printer Brand: Ultimaker
Printer: Ultimaker 2
Rafts: No
Supports: No
Resolution: 0.1
Infill: 20%

Notes: 
  I used a small brim to aid adhesion with these models, and the samples are printed in 0.15 res. I recommend a 0.1 res, but I was in a hurry to have examples printed before I had to leave my house. 

 The barrow entrance may be too small for some tastes, but it can be scaled up to 2x larger without a loss of quality. At one and a half scale the entrance is about shoulder height on most 25mm miniatures.

# Post-Printing

   As I usually do with any dungeon-terrain print, I sanded the edges where the brim had been attached and put down a black base coat on these pieces. I then proceeded to paint them with Vallejo model colors.