.:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2987654
Gloomhaven Tree with Leaves by VirtuallyJason is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

This is a new 3 Hex Gloomhaven Tree to replace the existing overlay tiles (3).  Since my bushes worked well, I decided to try the same treatment on a tree, which was even harder to print.  I've got it worked out pretty well (although it needs a *lot* of support), so I'm sharing it now (I'm printing my third one as I type this).  I uploaded the whole tree, as well as a version that's cut and keyed for easier printing (the key is very forgiving).  I also uploaded my supported version of the top, which is designed for a 1 mm layer height and a .4 mm nozzle.  Smaller nozzles should work fine, but you could use a smaller support interface to make it easier to remove.

It's not easy to remove the support material.  Just go at it with patience, removing 1 cm at a time, snipping the bits that are easy to get at as you work your way in towards the middle.  I printed it with a brim on the top half, to give the support trees as much stability as possible (so the whole thing has a single big footprint).

If you want more details about the tree and how I got it printed, check out my blog post at http://objectforge.blogspot.com/2018/07/new-thing-trees-for-gloomhaven.html