Homeworld - Taiidan Attack Bomber
Finished size approx 15cm.
Created by Arsenic Hipster

Bomb Launchers - Start at the vent hump and work you way around joining the edges finishing on the flap with the white square. Leave the front and rear end flaps open to allow access to the inside while you work. When the hull is finished these are attached to the sides.

Engine Intakes - Make each of these before the hull to give them time to dry.

Hull - Begin with the nose and work your way towards the back. Attach the two side panels beginning with the bottom and making sure they are lined up accurately. Once these are are attached join the engine intakes to the main hull. If you forgot which is left or right they have the small vent at the bottom with the red and white triangle on the outsides. Go carefully with these giving the glue on each tap time to dry a bit before pulling another into place. Continue joining the edges around the hull leaving the white flap until last.

Engine - Fairly simple just join the tabs then attach it to the main hull. Again you might want to insert some wire or something here to attach the fins with.

Pick your nose (don't groan it had to be said). I have included two versions of the nose for this model. One is the original for the people who just have to have it. But I expect it will be difficult to make with all those tiny little sides (I wasn't even going to try). The other is a version with a reduced number of polygons, its easily made but still very close to the original shape.

Make the remaining pieces (cockpit, chin, fins) and then attach them to the main hull and you're finished.