Homeworld - Taiidan Interceptor
Finished size approx 15cm long unless you change it.
Created by Arsenic Hipster

I made this model in several sections then attached the other parts as it was finished.

Engine - Start with the top section and join the ring that goes around the engine, then when its dry enough attache the end section. Attach the engine bottom part and work towards the front with the white flap last. Before closing this bit you could insert some pieces of wire, toothpicks or paperclips etc to attach the fins to later.

Centre Hull - Just start at one end and work you way around. If you picked the right start point the final section shoudld just have a flap to press down.

Forward Hull - Join the 4 sections together. and then attach to the Engine Intake. Getting these two parts aligned properly is probably the hardest part just start with 1 flap then work you way around as the others join. You might also wan to attach the nose and cockpit at this point. The hump behind the cockpit is best left until you have joined the jorward and centre hull sections together, or connected to the forward hull by the front flap only and completly glued down once the hull sections are joined properly.

Join the engine section and Forward Hull to the Centre Hull then attach the remaining parts such as the gun, tail and fins.